7. Select HEADER in box (A) by scrolling down to the
box using the scroll knob, and then pressing the check
mark button (knob and button are shown in Figure
3.220: John Deere Combine Control Console, page
153
).
8. Scroll down to the lower right icon that resembles an
arrow in a diamond (B) and press the check mark
button to select it.
Figure 3.219: John Deere Combine Display
Figure 3.220: John Deere Combine Control
Console
A - Scroll Knob
B - Check Mark Button
9. Follow the steps listed on the monitor to perform
the calibration.
NOTE:
If an error code appears on page, the sensor
is not in the correct working range. Refer to
Checking Voltage Range from the Combine Cab
(John Deere S and T Series), page 156
to check
and adjust the range.
147831
153
Revision A
Summary of Contents for FlexDraper FD1 Series
