214325
40
Revision A
Figure 3.58: Float Lock in UNLOCK Position
23. Disengage each adapter float lock by moving latch (A)
away from adapter and moving both header float lock
levers (B) down (UNLOCK).
24. Proceed to
3.4 Completing Header Assembly, page 79
.
3.3.3
John Deere Combines
Installing Reel Fore-Aft/Header Tilt Switch: S and T Series Combines
The reel fore-aft/header tilt switch allows the combine Operator to select either REEL FORE-AFT or
HEADER TILT mode.
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
This procedure is applicable to John Deere S and T Series combines only. For John Deere 60 or 70 Series
combines, refer to
Installing Reel Fore-Aft/Header Tilt Switch: 50, 60, and 70 Series Combines, page 45
.
IMPORTANT:
To prevent damage to electronic components, disconnect the positive cable from the combine battery and turn the
battery disconnect switch to the OFF position before connecting the reel fore-aft/header tilt harness to the
combine
’
s auxiliary power connectors.
Prepare the combine cab for switch and harness installation as follows:
