215626
79
Revision A
Removing and Reinstalling Idler Roller
The front skid must be removed and the draper loosened in order to access the idler roller.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, stop engine, remove key, and engage
safety pin before going under machine for any reason.
1.
Shut down the engine, and remove the key from the ignition.
2.
Ensure that the deck safety pin is engaged.
3.
Remove the front skid. Refer to
4.1.4 Adjusting Front Skid, page 74
for instructions.
$
%
Figure 4.16: Idler Roller
4.
Loosen the draper. Refer to
4.1.1 Adjusting Draper Tension,
for instructions.
NOTE:
The draper does not need to be removed to complete this
procedure; however, removing the draper will make this
procedure easier.
5.
Remove idler roller (A) by removing bolt and washer (B) at
each end of the roller.
To reinstall idler roller (A):
$
%
Figure 4.17: Idler Roller
6.
Reattach bolt and washer (B) at each end of the roller.
7.
Tighten the draper. Refer to
4.1.1 Adjusting Draper Tension,
for instructions.
8.
Reattach the front skid. Refer to
for instructions.
9.
Torque bolts (B) to 95 Nm (70 lbf·ft).
4.1.7
Replacing Draper Roller Bearing and Seal
You will need a slide hammer to remove the bearing from the draper roller.
1.
Remove the roller assembly. For instructions, refer to
