215626
35
Revision A
$
Figure 2.58: Case Drain Hose
To install case drain hose (A), proceed to the section that
applies to your windrower/header configuration:
•
M150/M200 and A Series without reverser. Refer to
Headers without Reverser, page 35
•
M150/M200 and A Series with reverser. Refer to
Headers with Reverser, page 36
.
•
M150/M200 and D Series without reverser. Refer to
Headers without Reverser, page 37
•
M150/M200 and D Series with reverser. Refer to
Headers with Reverser, page 38
.
•
M150/M200 and R Series. Refer to
2.6.5 Installing Case Drain Hose
M150/M200 and R Series Headers, page 38
•
M155/M155
E4
/M205, all header types. Refer to
2.6.6 Installing Case Drain Hose
2.6.1
Installing Case Drain Hose
–
M150/M200 and A Series Headers without
Reverser
The case drain hose must be connected to the header drive block on M150/M200 windrowers using A Series headers
without reversers.
$
%
&
Figure 2.59: Header Drive Block
1.
Connect #12 ORB x #10 JIC elbow (B) to port T on the
header drive block.
2.
Connect #10 JIC x #6 JIC reducer (C) to elbow (B).
3.
Attach case drain hose (A) to reducer (C).
NOTE:
Make sure that hose (A) is not rubbing against any fittings.
Refer to
5.5 Hydraulics and In-Cab Electrical, page 98
for
additional information on the hydraulic connections.
4.
Proceed to
