To reinstall the drive roller on the deck, follow these steps:
1.
Slide the drive roller onto the motor shaft. Make sure it
is fully engaged.
NOTE:
The drive roller should be 33 mm (1-1/3 in.) (A)
from the face of the motor.
Figure 4.12: Drive Roller Cross Section
2.
Install the two set screws (B) and torque to 27 N·m
(20 ft·lbf).
3.
Install the two jam nuts (A).
NOTE:
The second jam nut and set screw are on
the opposite side and are not visible in this
illustration.
Figure 4.13: Draper Drive Roller
4.
Install washer and bolt (B) into drive roller (A) and
torque to 95 N·m (70 ft·lbf).
Figure 4.14: Draper Drive Roller
Removing and Reinstalling the Idler Roller
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, stop engine, remove
key and engage safety pin before going under machine for any reason.
214048
47
Revision A
Summary of Contents for DWA
