5.5
Centering the Reel
If the reel is not centered between the endsheets, refer to the topic for the header type:
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
•
5.5.1 Centering Double Reels, page 61
•
5.5.2 Centering Single Reels, page 62
5.5.1
Centering Double Reels
1.
Measure clearances at locations (A) between reels and
both endsheets. The clearances should be the same
if the reels are centered. If not centered, continue on
the next step.
Figure 5.13: Double Reel Measurement
Locations
2.
Loosen bolts (A) on each brace (B) located on both
sides of the reel support arm (C).
3.
Move the forward end of the reel center support arm (C)
laterally as required, to center both reels.
4.
Tighten bolts (A) and torque to 265 ft·lbf (359 N·m).
Figure 5.14: Reel Center Support Arm
214017
61
Revision A
