215184
342
Revision A
9.1.7
Case IH 7010/8010, 120, 230, 240, and 250 Series Combines
Checking Voltage Range from the Combine Cab
–
Case IH 8010
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
WARNING
Check to be sure all bystanders have cleared the area.
1.
Position the header 150 mm (6 in.) above the ground, and unlock the float.
1013274
A
Figure 9.79: Float Lock
2.
Check that float lock linkage is on down stops (washer [A]
cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the next two
steps, the voltage may go out of range during operation
causing a malfunction of the AHHC system.
1015833
A
B
Figure 9.80: Float Indicator Box
3.
Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on float indicator is on
0
.