MAC215986
466
Revision A
ϭϬϯϴϯϭϰ
A
B
Figure 4.387: Pin Location
–
Left Outer Wheel
14. Remove pin (A).
15. Reposition adjuster plate (B) in the slot to align with a
different hole. There is approximately 24 mm (1/2 in.)
difference between each of the holes.
•
If the measurement is less than the measurement at the
center of the header, move the adjuster plate
TOWARD
the cutterbar.
•
If the measurement is more than the measurement at
the center of the header, move the adjuster plate
AWAY
from the cutterbar.
16. On the opposite end on the header, repeat Step
and Step
17. Disengage the header safety props. Refer to the combine operator
’
s manual for instructions.
18. Lower the header until the auto header height indicator is at number 2.
19. Shut down the engine, and remove the key from the ignition.
20. Measure the guard to ground distance again. Verify that the three measurements are the same. If more adjustment is
required, repeat Step
.
4.15.2
Lubricating Contour Wheel System
Lubricating the contour wheel system will help ensure reliable operation and maximize the service life of the components.
The components of the contour wheel system require lubrication at different intervals:
•
Lubricate the inner wheel assemblies every 250 hours
•
Lubricate the wheel axles annually
DANGER
To avoid bodily injury or death from unexpected startup or fall of raised header, stop the engine, remove the key, and
engage the safety props before going under the header. If you are using a lifting device to support the header, be sure
that the header is secure before proceeding.
1.
Start the engine.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the header safety props or support the header on blocks on level ground. If using blocks to support the header,
ensure the header is approximately 914 mm (36 in.) off the ground.
