214805
65
Revision A
Hydraulic hose connections:
1022379
A
B
C
D
D
Figure 3.135: Factory Configuration
–
M150, M155,
M155
E4
, and M200
4.
Disconnect hoses as follows:
a.
Disconnect hose (A) from tee (B).
b.
Disconnect tee (B) from the reel motor upper port.
c.
Disconnect hose (C) from the reel motor lower port.
5.
Cut cable ties (D) at locations shown in illustration.
1010927
A
B
C
D
E
F
Figure 3.136: Adjusted Configuration
–
M100, M105,
and M205
6.
Reconnect hoses as follows:
a.
Reroute hose (E) behind hose (A) and (F) to hose (C)
and connect tee (B) to the lower port fitting.
b.
Reroute hose (C) above hose (E) and (F) and connect
hose (C) to tee (B). Tighten hose (C).
c.
Loosen 45-degree fittings at both ports. This allows
room for wrenches when tightening tee (B) to
lower port.
d.
Connect hose (A) to upper port fitting as shown and
check orientation of 45-degree fitting.
NOTE:
Ensure that hose (A) is routed in front of hose (C) and
hose (E).
e.
Confirm orientation of the upper port 45-degree fitting,
back-off tee (B), and tighten the upper port fitting in
position determined. Tighten hose (A).
f.
Check orientation of the lower port 45-degree fitting
and tighten.
g.
Connect tee (B) to the lower port 45-degree fitting and
tighten.
