2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before instal-
ling, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before re-
suming use.
WARNING
Do not carry the tool by the
hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
USING THE POWER MANAGEMENT SYSTEM
Air wrenches are not torque control devices. Fasteners
with specific torque requirements must be checked
with suitable torque measuring devices after
installation with an air wrench.
MODEL AW3800
POWER MANAGEMENT SYSTEM
(Dwg. TPD2035)
POWER SETTING INDICATORS
MAXIMUM
MINIMUM
POWER
MANAGEMENT
DIAL
Model AW3800 Impact Wrench incorporates a Power
Management System that allows the operator to select four
power output settings. These settings range from
minimum power output through maximum power output
in the forward direction only.
The Air Wrench will always operate at maximum
power output in the reverse direction, no matter what
power output level is selected.
The four power setting indicators of increasing size on
the rear of the housing indicate increasing power
output levels, are for reference only and DO NOT
denote a specific power output. The smallest power
setting indicator designates minimum power output,
the two middle power setting indicators denote medium
power outputs and the largest power setting indicator
denotes maximum power output.
The power output can be further reduced in forward
or reverse by using the variable throttle. Air supply
systems which do not deliver adequate air pressure can
affect power output at all settings.
