Instruction Manual
MAN-004
15
www.macmedical.com
Plumbing Access ( Manual Knee Operated Sinks Only)
1. Open the knee panel door by depressing the latch at the bottom of the panel door (Fig. 24).
2. Swing the door fully open to access the hinges (Fig. 25).
3.
Push the hinge pins inward to release the door from the hinges (Fig. 26).
Infrared Controls (for Infrared Self-Activated Sinks only)
Installation
The sinks are supplied with a 24V power transformer(s) that connects
to a standard duplex outlet (110/120V outlet required).
Single basin sinks have one sensor, dual basin sinks have two sensors
(one for each basin) and triple basin sinks have three sensors (one for
each basin).
1.
Plug the transformer(s) into the outlet.
2.
A red LED will flash in the sensor window (Fig. 29 - circled in red).
A.
Important:
Do not interrupt the sensor beam until the light
turns off.
Operation
The sensors are pre-set and equipped with a logic board. The sensors
determines the range during initialization period (The time after initial
power until the light turns off is approximately 5 minutes). The range is
approximately 12-14” in front of the sensor and is 25 degrees at peak.
During the initialization period, the sensors allow for fixed objects that
may be within the sensors’ range. The sensors are equipped with a 2
second on/off delay, and no-time-out feature. This prevents the sink
from turning on when walking past at a normal pace and no-time-
out allows for an uninterrupted scrub.
4. To re-attach the door, push in the hinge pins
and fit the top corners of the knee panel
door onto the left and right hinge leaves (Fig.
27 - circled in red). When the door is refitted,
release the hinge pins to secure the door to
the sink.
5. The knee panel door should rotate freely on
its hinges. Rotate the door back down on its
bottom latch to close it (Fig. 28).
Fig. 24:
Push down knee panel door latch
Fig. 25:
Door in fully opened position
Fig. 26:
Push hinges inward
Fig. 27: Left - right hinge leaves
Fig. 28:
Door should rotate freely on hinges
Fig. 29: Location of infrared sensor
