PAGE | 02
10
11
12
Remove the
cap from the
soap
container.
Fill the soap
container with
FOAM SOAP
ONLY.
DO NOT USE
GRIT TYPE
SOAPS.
Put back the
cap and close
the soap
container.
08
Remove the soap
Container and
install the soap
dispenser in place,
fasten securely.
09
Put back
the soap
container,
making sure the
pump is inserted
in the yoke
13
14
02
03
15
01
Take the
battery case
out of the
compartment
Pull the tab
out of the
battery case,
& insert case
back in the
battery case
compartment
Tab
Pump
lnsert six (6)AA size alkaline
as shown in Battery
compartment figure 02.
Close the compartment
by sliding the tab until it
clicks into in place.
Close the cover,
make sure the
cover is locked
and secured
against the back
plate.
Usage:
Replacing Batteries
01
L
oading batteries and the LED will flash 3 times
indicating the dispenser is ready for use. Place hand(s)
underneath dispenser within 5" of the sensor, the
dispenser will dispense approximately 0.8ml of foam
soap into your hand(s).
02
Note:
1. The dispenser cover must be closed to activate.
2. When the batteries are too low, the LED will blink
continuously. The dispenser will not work, change the
batteries inmmediately.
*Please pass the instruction to the user after finish install
Battery
compartment
open
Push the Battery
Case to close
Press this tab
to Open
For reference See Replacement Batteries
Back Plate
Soap re-fill
Pump
Battery Case
Battery
Compartment
Cover
Power Switch
Yoke
Led Indicator
8
66 558 3200 310 919 3073 [email protected] www.macfaucets.com
M
AC FAUCETS
California, USA