PAGE | 01
Installation Instructions
User Manual
Automatic Foam Soap Dispenser
Model:
ASD-23
ASD-23
Soap Dispenser
Stainless Steel Construction
Dispenses
Foam Soap Only
,
commonly found in retail stores
1000ml Integral / Soap Bottle
Vandal Key
Integral Battery Compartment
Mounting Hardware
Batteries Pre-installed
(6 AA)
All hardware necessary for satisfactory installation
Package Includes
8
66 558 3200 310 919 3073 [email protected] www.macfaucets.com
M
AC FAUCETS
California, USA
DE
SIGNED &
A
SS
EM
BLED IN TH
E U
SA
3-11/116”
10-13/16”
4”
01
05
07
Please cut for drilling holes
Drill Holes Ø 1/4”
Once the location for the Soap
dispenser has been decided,
proceed with the installation
steps below. If the soap
dispenser is installed above the
sink, leave a space of 18” from
the top of the sink to the soap
dispenser as shown below in
figure (A).
1. Cut the template from the
back of the dispenser box.
2. Use a level to align the
template correctly.
3. Use painters tape to hold the
template in place.
4. Drill holes for supplied plastic
anchors.
03
04
02
Place the plastic anchors in the holes. Drive them
in with a lite hammer.
Align the holes of
the dispenser with
the holes of the
anchors. Insert
screws in and
fasten using a
Phillips screw
driver.
Make sure that there is
8" minimum distance
between top of sink to
bottom of soap
dispenser
Insert the key into the hole
located at the top of the
dispenser, push down with the
key and pull the cover forward.
The cover engages a power
cut-off switch located in the
dispenser. The dispenser will
not activate when the cover is
in the open position.
Tools Needed
Safety Glasses
Drill bit
Ø 1/4” Carbide
Drill for tile
Cordless Drill
Hammer
Level
Phillips Screw Driver
Tape
06
8”
Fig. A