1. Place bottom of pressure washer frame on a
flat, even surface. Temporarily place unit on
blocks to ease assembly.
2. Slide axle through holes in frame, as shown in
Figure 1.
3. Slide a wheel over the axle.
NOTE
: Be sure to install wheel with raised hub
inboard.
4. Retain wheel on axle stud with retaining pin.
See Figure 1.
5. Repeat step 3 and 4 to secure second wheel.
6. Remove temporary blocks.
Add Engine Oil and Petrol
• Place pressure washer on a level surface.
• Damage to equipment resulting from failure to
follow this instruction will void warranty.
• Refer to engine operator’s manual and follow oil
and petrol recommendations and instructions.
NOTE
: Check oil often during engine break–in.
Refer to engine operator’s manual for
recommendations.
CAUTION
: Any attempt to crank or start the engine
before it has been properly filled with the
recommended oil will result in equipment failure.
• Refer to engine manual for oil and petrol fill
information.
• Damage to equipment resulting from failure to
follow this instruction will void warranty.
Connect Hose and Water Supply to
Pump
IMPORTANT
: To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1. Uncoil high pressure hose and attach one end
of hose to base of spray gun. Tighten by hand.
NOTE
: Remove and discard all pump shipping caps
before attaching hoses.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Before connecting garden hose to water inlet,
inspect inlet screen (Figure 2). Clean screen if it
contains debris or have it replaced if damaged.
DO NOT run pressure washer if inlet screen is
damaged.
4. Run water through your garden hose for
30 seconds to flush out any debris.
IMPORTANT
: Do Not siphon standing water for the
water supply. Use ONLY cold water (less than 38°C
/ 100°F).
5. Connect the garden hose (not to exceed 15 M /
50 FT in length) to the water inlet.Tighten by
hand (Figure 2).
CAUTION
: There MUST be at least three meters of
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
‘Y’ shut-off connector or other convenience-type
water shut-off valve.
• Damage to equipment resulting from failure to
follow this instruction will void warranty.
NOTE
: This unit is equipped with a 14MM and a
20MM hose adapter. If using either adapter, obtain a
suitable hose clamp to secure the hose to the
adapter.
6. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air
and impurities.
WARNING
: High pressure spray can cause paint
chips or other particles to become airborne.
• Always wear safety goggles when using this
equipment or in vicinity of where equipment is in
use.
• Before starting the pressure washer, be sure you
are wearing adequate safety goggles.
7
Figure 2
