1. Slide nozzle forward when you wish to adjust
spray to low pressure mode.
2. Slide nozzle backward to achieve high pressure.
3. Point nozzle down towards a firm surface and
press trigger to test pattern.
4. Twisting nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
Usage Tips
• For most effective cleaning, keep spray nozzle
from 20 to 60 CM (8 to 24 IN) away from cleaning
surface.
• If you get spray nozzle too close, especially using
high pressure mode, you may damage surface
being cleaned.
• Do Not get closer than 15 CM (6 IN) when
cleaning tires.
Applying Detergent with
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers.
Household detergents could
damage the pump.
CAUTION
: You must attach all hoses before you
start the engine.
• Starting the engine without all the hoses
connected and without the water turned ON will
damage the pump.
• Damage to equipment resulting from failure to
follow this instruction will void warranty.
To apply detergent, follow these steps:
1. Review use of adjustable nozzles.
2. Prepare detergent solution as required by job.
3. Place filter end of detergent siphoning tube into
detergent container.
CAUTION
: Keep the detergent siphoning tube from
coming in contact with the hot muffler.
• When inserting the filter into a detergent solution
bottle, route the tube so as to keep it from
inadvertently contacting the hot muffler.
4. Slide adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with nozzle
in high pressure position.
5. Make sure garden hose is connected to water
inlet. Check that high pressure hose is
connected to spray gun and pump. Start engine.
6. Apply detergent to a dry surface, starting at
lower portion of area to be washed and work
upward, using long, even, overlapping strokes.
7. Allow detergent to "soak in" for 3-5 minutes
before washing and rinsing. Reapply as needed
to prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT:
You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer
in low pressure for 1-2 minutes.
Pressure Washer Rinsing
For Rinsing:
1. Slide the nozzle backward to high pressure,
press the trigger and wait for the detergent to
clear.
NOTE
: You can also stop detergent from flowing by
simply removing detergent siphoning tube from
chemical container.
10
