24
Drive motor runs but dryer does not heat.
0
50,000 Ohms +/-10%
Drive motor runs but dryer not heat.
Check the resistance of the control thermistor at
room temperature.
Defective thermistor.
Program the dryer for a
NORMAL
Cycle with
HIGH
Temp and
touch
START
. Measure the voltage drop
between the two terminals of RL2.
Defective electronic
control board.
Measure the voltage drop between the two terminals of the
high limit thermostat.
Defective high
limit thermostat.
Remove power from the dryer and disconnect the black wire
from RL2. Restart the dryer and measure the voltage drop
between red wire on RL2 and neutral.
Open wire from
terminal block.
Remove power from the dryer, reconnect the black wire from RL2
and disconnect the plug from the drive motor. Restart the dryer and
measure the voltage drop between yellow and white wire in the plug.
Defective motor.
Defective
heating element.
More or less than
50,000 Ohms +/-10%.
240 VAC
0
240 VAC
0
120 VAC
120 VAC
0
mabe CONFIDENTIAL AND PROPRIETARY INFORMATION-NOT FOR PUBLIC DISCLOSURE. January 2007