MA Lighting Technology GmbH . Dachdeckerstr. 16 . D-97297 Waldbüttelbrunn . Fax: + 49 9 31 4 97 94 29 . www.malighting.de
34
34
34
34
34
5.1.2 Programming chaser parameters
SPEED
- sets the time between the different steps
STEP FADE- sets the x-fade time between the single steps
STEP TRIG
- sets the trigpoint between the single steps
As the STORE MATRIX may be different from step to step, the listed parameters
are global for the complete chaser program.
Encoder 2
Speed in Hertz (steps / sec.) and in seconds.
STEP FADE or
STEP TRIG
Inverts the respective block in the display. In case
LINK FADE is selected, the fade time is set in
percentage of the step time
Encoder 3
Changes the selected parameter. The step fade is
allowed to be longer than the step time (SPEED).
This makes sense if the fading channels are not
selected in the next step. Otherwise they will not find
the time to do their fade. (>> selective programming)
CHASER SPEED
STEP FADE
STEP TRIG
5.1.3 Insert or delete chaser steps
Any time a chaser button is selected to store a new step, the step counter will
automatically jump to the old step 1. This way the new picture will
be added as the new last step of the chaser.
Encoder 1
Selection of a step number.
INSERT
Shifts the selected step and all following steps one
step back and inserts the new picture at the selected
place.
STORE button
Overwrites the selected step by the new picture. The
total number of steps stays unchanged.
Step sequence
Insert a new step
Overwrite an old step
