- 1 -
SPECIFICATIONS
•
Model
HK-2000D
•
RMS Power @ 14.4V
4 Ohm
750W
2 Ohm
1000W
1 Ohm
1500W
•
RMS Power @ 17.0V
4 Ohm
1000W
2 Ohm
1500W
1 Ohm
1800W
•
Signal to Noise Ratio
>96dB
•
THD Level
4 Ohm
0.05%
2 Ohm
0.5%
1 Ohm
1.0%
•
Frequency Response
10Hz - 350Hz
•
24dB Low Pass Filter
50Hz - 350Hz
•
24dB Subsonic Filter
15Hz - 50Hz
•
Bass Boost Control at 45Hz
0 - 18dB
•
RCA Input Sensitivity
0.2 - 8V
•
Low level Input Impedance
22K Ohms
•
Damping Factor
200 @ 4 Ohm
•
Fuse Rating
40A x 4
•
Dimensions (W x H x D)
12.4” x 2.71” x 14.29”
- 2 -
FEATURES & CONTROLS
RCA Line Input Jacks:
To be connected to a line driver, crossover or head unit via RCA Cables.
RCA Line Output Jacks:
For connecting additional amplifiers using a daisy chain effect.
Remote Socket:
External Remote Controller for Sub Level Control.
24dB Subsonic Filter Control:
Permits a 24dB per octave high pass filter between 10-50Hz
24dB Low Pass Variable Control:
Adjustable low pass crossover frequency from 50Hz – 350Hz
0-18dB Bass Boost Control:
The Bass Boost control is used for a 0-18dB gain at 45Hz for extra bass punch.
Input Gain Level Control
For adjusting the output of the amplifier to the input of the source unit.
Adjustment range is from 0.2V to 8.0V
Power LED:
The Blue color LED indicates that the power is on.
Protection LED:
The Red color LED indicates fault condition of amplifier.
When a fault condition occurs such as an overload, excessive heat or short circuit of speaker
terminals, the protection circuit is engaged to protect both the subwoofers and amplifier.
Parallel Mode:
This Digital Amplifier has a Parallel Mode (Strapped)
This function is used to generate an extreme amount of output power by combining two
amplifiers together to power the same voice coil.
MASTER AMP - When using this option, the master amp has control over the slave amp.
SLAVE AMP
- When using this option, the slave amp has no control.
The slave amp only role is for increasing total output power.
Power Connection:
Co12V DC power wire from battery source to amplifier.
Ground Connection:
Connects the Ground wire of amplifier to the chassis ground.
Remote Connection:
Connects the remote wire allowing the amplifier to be turned on/off by the head unit.
Speaker Terminal:
It allows the connection of a speaker to the amplifier.
Fuse:
Protection for the amplifier.
External Remote Accessory:
Used for remote subwoofer level control via harness from amplifier
