VAN DER GRAAF
VERY LOW NOISE POWER SUPPLY
REVISION P
R
A – JUNE 2014
Copyright © 2014, M2Tech Srl
9
M2Tech
www.m2tech.biz
1. Unpacking and Placing the Unit
Lay the box on a table and open it by separating it from the external paperwork and
removing or cutting the adhesive tape seal. The following items are included:
•
one
VAN DER GRAAF
;
•
one power cord;
•
two output cables with 5.5/2.1mm jacks;
•
two output cables with 4-pole XLR connectors;
•
this manual.
Should one or more item be missing, please contact your retail dealer.
Remove the
VAN DER GRAAF
from the foam enclosure and place it onto a stable base,
far from heat sources. Avoid full sunlight on the unit. Allow for ample room around the
unit for venting.
The
VAN DER GRAAF
is a power supply capable of delivering up to 60VA when
operating. Even if its regulators are high efficiency ones, and even if not always all
outputs are used, the unit can produce a relevant heat. Therefore, an adequate air
flow is recommended.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any
signs of abuse will void warranty coverage.
Do not place the unit on thick carpets or inside a box or piece of furniture, not even
close to curtains.
