MANUNTA
BY M2Tech
www.manunta-audio.com
EVO Phono 3
Phono PreamplifiER
REVISION P
R
A – November 2022
5. Connecting and Powering the Unit
WARNING: All connections between the
Evo Phono 3
and other equipment must be
made when all units are turned off and completely powered down or unplugged.
Failing to do so may cause damage to the
Evo Phono 3
and/or other units.
Please refer to chapter 3, “Back Panel”.
Connect the cable from the turntable to one of the input pairs (Figure 2, 11-12). When two
turntables or a turntable provided with two arms is used, both inputs can be used.
Connect the
Evo Phono 3
output pair to a pair of inputs on an integrated amplifier or
preamplifier (Figure 2, 13).
Connect the plug from the stock wall wart or from the
Evo Supply 3
to the
Evo Phono 3
power input (Figure 2, 14).
Connect the wall wart or the
Evo Supply 3
to a mains outlet. The former will automatically
accept any voltage from 90V
AC
to 265V
AC
.
Switch the
Evo Phono 3
on by pushing the left front panel button (Figure 1, 2). If you’re
using the
Evo Supply 3
, you have to activate the output used to power the
Evo Phono 3
first.
NOTE: it is possible to use a dedicated low noise power supply in place of the wall
wart, to increase the sonic performance
Manunta by M2Tech
provides a device for
this purpose, the
Evo Supply 3
.
M2Tech
’s
Van Der Graaf M
k
II
can also be used. Should
the user opt for use of power supply not provided by
Manunta by M2Tech
or
M2Tech
,
we reserve the right to void the
Evo Phono 3
warranty
.
Copyright © 2022, M2Tech Srl
15