m2m Germany GmbH | Am Kappengraben 18-20 | 61273 Wehrheim | 06081 5873860
OUT
:
set to force a change of the output (default: off).
DST
:
set to change DST (default: none).
No time sync
:
set to disable time synchronization request (default: enabled).
Normally sensor asks for a time sync at every power on (uplink starting with 01) or, if enabled, once a week.
Please check chapter 2.1
.
UnConfirmed
:
set for unconfirmed uplinks (default: confirmed uplink).
Led Off
:
set to disable the system leds (default: enabled).
Input counter
:
set to enable the pulses counter funcion (default: disabled).
Single join/day
:
set for to allow only one join per day (default: multiple join allowed).
Counters period [min]
:
if counter enabled, this is the interval (in minutes) between one measure and the next one. The sensor sends one measures for every transmission. Value can be
between 1 and 255 minutes (default: 0 minutes). Period interval can be set with App or with downlink command.
I/O period [min]
:
if different from 0, this is the interval (in minutes) between one I/O messages status and the next one. Value can be between 1 and 255 minutes (default: 0 minutes -
disabled). Period interval can be set with App or with downlink command.
5 Passwords
The device can be protected by passwords, to avoid unauthorized persons to read data or modify parameters.
As default passwords are equal to 0.
Allowed values range from 0 to 999999999 (only numbers).
To change the passwords, set the new values with the LoRa Tool App:
