www.redrockmicro.com
M2 Cinema Lens Adapter Manual
page
12
©2006 Redrock Microsystems, LLC. All Rights Reserved.
Installing the 9-volt Battery in the M2 Housing
The M2 Housing contains a motor that powers the Cinescreen. A 9-volt battery is supplied. You must
install the 9-volt battery inside the M2 Housing on the inside of the Cover Assembly, and replace the
battery when it is low.
There is no need to remove the Cover Assembly to replace the battery. There
is a Battery Access Panel on the underside of the M2 Housing.
(1) Open the Battery Access Panel on the bottom of the M2 Housing by removing the screws.
(2) Install the battery and attach the wire cap to the 9-volt. The battery will fit snugly inside the Cover
Assembly in the provided location.
(3) Replace the Battery Access Panel and install the screws.
Redrock micro sells an optional AC adapter. The adapter can be plugged in while the battery is
installed. There is no need to remove the battery to use the AC adapter.
Some people have used rechargeable batteries strapped to the outside of the M2 Housing and
connected through the AC adapter receptacle to power the motor.
At least one person has reported leaving the M2 motor running on a single 9-volt battery and it was
still in operation after 24 hours. Your experience may vary.
