User guide for Shower/Commode chair M2 El-Tip with Joystick.
Intented for use a bathing, showering and toilet visit.
(3/7)
Back adjustment
You open the back by pressing the two plastic
taps with your left hand, and then with your
right hand you pull the buckle out.
The depth of the back is adjusted by pulling the
webbing and then tighten it.
Care: Washable at maximum 80 degrees.
Mounting the footrests
The height of the footrests are adjusted by
taking the clips out and subsequently placing
the footrests in a suitable height and then
reinserting the clip. Placing the footrests on
one side: You lift the footrests slightly and
swing them to either side you want. If you want
the footrests to occupy lesser space you are
able to tilt them.
Calf support adjustment
The calf support is fastened with velcro tape
on the backside.
The depth and the Calf support is adjusted by
fastening the velcro tape further in or further
out.
Car: Washable at maximum 80 degrees.
The pan/bucket
When sliding the bucket of the chair, it is
important to slide it straight backwards, along
the seat. Otherwise it can be very difficult to
get the bucket of the chair.
Side support adjustment
The side supporters are clicked into place in
the square pipes on the side of the chair.
The depth is adjusted by loosening the finger
screw and then tightening it again once the
height is right. You can also fasten the side
supporters so that the cushions are turned
horizontally if there is a need for that.
Continued on page 4