M6SCTC
P. 2 / 4
EM-7972 Rev.4
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
Set the unit so that its DIN rail adapter is at the bottom.
When the unit is installed to an Installation Base (model
M6SBS), refer to its instruction manual.
■
MOUNTING THE UNIT ON A DIN RAIL
A) Hang the upper hook at the rear side of unit on the DIN
rail.
B) Push in the lower in keeping pressing the unit to the
DIN rail.
■
REMOVING THE UNIT
A) Pull down the DIN rail adaptor using a minus screw
-
driver.
B) Pull out the lower part of the unit.
C) Remove the upper part from the DIN rail.
TERMINAL CONNECTIONS
Connect the unit as in the following diagram or refer to the connection diagram on the side of the unit.
■
EXTERNAL DIMENSIONS unit: mm (inch)
A
DIN Rail
B
A
DIN Rail Adaptor
C
B
INSTALLATION
94 (3.70)
5.9 (.23)
DIN RAIL
35mm wide
DIN RAIL HOOK
*
Use a minus screwdriver: tip width 3.8 mm max., tip thickness 0.5 to 0.6 mm
102 (4.02)
[0.5 (.02)]
SCREWDRIVER
INSERTION ANGLE
: approx. 40°
WIRE INSERTION ANGLE
: approx.35°
TEST PROBE
max. 2 (.08) dia.
SCREWDRIVER
*
INSERTION ANGLE
: approx. 35°
5
6
7
8
1
2
3
4
• When mounting, no extra space is needed between units
.
