![background image](http://html2.mh-extra.com/html/m-system/47-series/47-series_operating-manual_3059829172.webp)
172
47DR OPERATING MANUAL EM-9509-B Rev.7
25.1 DEVICE ADDRESS
25.1.1 OPERATING PROCEDURE
NOTE
The following figures are display examples. The displays
depend on the settings.
1
Hold down Alarm/
↓
and Shift buttons at once for 3 seconds or
more to move on to Modbus Setting Mode.
• The device address is indicated.
• The SD indicates ‘EQP-NO’.
2
Press Shift button to shift the display into the setting standby
mode. Then press Shift and Up buttons to set the device ad-
dress.
• The third digit starts blinking, to which you can apply changes.
• Set within the range of 001 to 247.
3
Press Alarm/
↓
or Init/
↑
button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/
↓
button, and the baud rate will be indicated (‘B-RATE’ on the SD).
• Press Init/
↑
button, and the long register will be indicated (‘L-WORD’ on the SD).
1,3
3
1,2
2
Blinking