M-LOCKS MiniTech, User Instructions

Page: 10 / 20

IU_MiniTech_05_eng 11 of 24
User instructions
MiniTech
Power up the keypad. Press and hold . LCD shows:
SYSTEM SETUP
Insert the setup Dallas key in the reader and connect the reader with
the keypad by means of the jack connector. LCD shows:
08:00 FRI
27/01/2019
Check time and date. Press to confirm or to update the values.
Then press again to confirm. LCD shows:
UPLOADING 10%
If the operation is successfully performed, LCD shows:
OPERATION DONE
Setup with PC
Power up the keypad. Press and hold . LCD shows:
PC LINK
Press , LCD shows:
PC LINK
...
Start the programming on the Setup software or press to exit.
If the operation is successfully performed, LCD shows the firmware
version and few seconds later the keypad switches OFF.
Opening with dynamic codes
Power up the keypad and insert the Dallas dynamic key in the Dallas
reader. Alternatively, press and hold to enter the dynamic user
PIN (optional). LCD shows:
DYNAMIC USER
X X X X
Enter the dynamic user PIN. LCD shows:
DYNAMIC CODE
X X X X X X X X X
Enter the dynamic code and press .
Open the lock within 3 seconds (green led ON).
If set by the software Dyama or Dyamaweb for dynamic codes creation,
LCD shows the closing code when the bolt re-closes. Please refer to the
user manuals IU_Dyama_XX or IU_DyamaWeb_XX for further
information.
CLOSING CODE
179
WARNING: dynamic codes must be used respecting the sequence of
activation time in which they have been created by the software
(Dyama or DyamaWeb), otherwise the last created code deletes all the
previous ones (i.e. if three codes are created and the third one is used
before using the first two ones, those first two codes are deleted). In
this case indeed LCD shows:
DYNAMIC CODE
DELETED