M-E CUVEO CT-FB16 Series, Manual

Page: 14 / 36

EN
14
will cause all Cuveo receivers configured
for the channels 1-8 or 9-16 (depending
on switch position) to be switched on (LED
on the receiver will flash) or off (LED on
the receiver will go out).
BATTERY CHANGE
Place the wireless remote control on the
front side (keypad), with the battery
compartment facing up. Open the
battery compartment by lightly pressing
the battery cap and sliding it up.
Place two 1.5 V (type: 1.5 V AAA)
batteries with correct polarity into the
battery compartment of the wireless
remote control. Replace the battery
compartment cap back on the wireless
remote control and slide it back down shut.
SERVICING AND CLEANING
Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need to
be serviced.
• The external surface can be cleaned by
using a dry, soft and clean cloth. Do not
press too hard on the front panel or on the
casing, as this can leave scratch marks on
the surface.
• Dust can be easily removed by using a soft
and clean brush with long hairs and bristles
and a vacuum cleaner. In no event must an
aggressive cleaning agent or other chemical
solutions be used since that can affect the
casing or impair its proper functioning.