M-E CUVEO CT-FB16 Series, Manual

Page: 13 / 36

EN
13
c.) Please repeat these steps for other
wireless transmitters.
Deleting the wireless remote
control on a Cuveo receiver
For this, please follow the instructions
contained in the instruction manual of
the Cuveo receiver.
FUNCTION TEST/OPERATION
Connect a device to the configured Cuveo
receiver. Please read the chapter titled
“Technical Details” of the respective Cuveo
receiver to find out about the permitted
maximum capacity of the device.
SWITCH FUNCTION
Operating the corresponding “ON” or “OFF”
button of the switch channel on the wireless
remote control will cause the Cuveo receiver
to be switched on (LED on the receiver
will flash) or off (LED on the receiver will
go out). By using the selection key “1-8”
– “9-16”, you can select which channel
series will be switched on by the press of the
buttons. That will make it possible to switch
“ON” or “OFF” or dim 16 different receivers
independent of one another.
DIMMING FUNCTION
Attention! This function is only available
for the dimmable Cuveo receivers. Once
the receiver is switched on, i.e. the device
(lamp) is powered on, pressing the “ON”
button can activate the dimming function.
Pressing the “ON” button a second time
switches off the dimming function and the
brightness of the lamp will continue to
remain at that level.
MASTER FUNCTION
Pressing the MASTER “ON” or “OFF”
BUTTON on the wireless remote control