16
INSTRUCTIONS FOR INSTALLATION AND USE 1000-1300RD GAS
CONVENTION OUTLET
CONVECTION INLET
You have to connect at least two appertures situated at the top of the appliance.
The appliance may not be placed directly on the floor, without the feet. This is to allow na-
tural convection. The appertures for the air supply are situated underneath the
aplliance.
Every opening you make must be connected with a flexible tube dia 150MM
(see pic below). This will avoid the heating of the electronic part of the appliance.
In this case you will have errorcode F02.
CONVECTION INLET
ATTENTION:
if the installer opens the openings in advance, these must be covered during the work
(grinding, drilling, sawing, etc.). Dust released during installation will otherwise sneak into
convection circuit. Dust can never be eliminated properly and give off a lingering smell when
using the appliance.
Once the installation is complete, it is imperative to aspirate or blow the convection
channels with compressed air (be sure not to return dust to the convection chamber of the
fireplace).
