INSTRUCTION FOR INSTALLATION AND USE - LUNA 550V - 550DV - 850V - 850DV GOLD - GAS
M-DESIGN
13
pic. 1
pic. 2
pic. 3
REFERENTIAL DISTANCES IN REGARDS TO FINISHING THE MANTLEPIECE
A very essential point when setting up the Luna Gold is that the distance has to be respected inbetween fireplace and the
finishing material for the mantlepiece such as marble, gipsum,...
For this, a small bended metal sheet that is provided ont the fireplace ( pic.1 ) , is to be used as the minimal reference for
the distance. The finishing can only ga oas far as this meteal sheet ( pic.2 ). Don’t remove this ( pic.3 ) ! This allows you to
take out the 4th side frame and to let the airflow in the mantelpiece for natural convection.
5.
INSULATION AND FINISHING
Once installation is complete, the appliance can be fitted. Before doing so, check the tightness of the gas pipe one more time. Light the
appliance and check that it is working: check the tightness of the gas pipe and the smoke pipe. Once you have checked everything,
you can perform the final insulating and finishing operations.
The built-in part of the furnace tends to be very warm. Please check that the furnace is not too narrowly fitted and that there is ade
-
quate space for the elimination of hot air. For insulation of the furnace, we advise you to use M Design insulating plates. You are
advised against using any other insulation product. Inflammable materials as well may not be used for the finishing.
The masonry must be raised around the furnace. Because of the expansion of the furnace during combustion, an interstice of at
least 5 mm must be provided on each side of the appliance. The masonry must not lean against the furnace.
THE APPLIANCE MUST BE SET FREE .
Please pay attention to leave approx. 2 mm inbetween the finishing frame and maconry ( see p.17 , mounting a 3-sided frame )
min. 5 mm
Please , follow this instruction. The appliance can overheat if you not apply those instructions. Errorcode F02 will appear !
