M-Audio Studiophile DSM3 Guide
10
Installing a Fuse
A 2.5 Amp fuse is required for both the
100–120V and the 220–240V settings.
To change the fuse:
1
Turn off power to the speaker and disconnect
the AC power cord.
2
Use a small screwdriver to remove the fuse
holder.
3
Remove the currently installed fuse.
4
Install the new fuse in the fuse holder.
5
Replace the fuse holder so that it clicks into
place.
Connecting Power
To connect power to the speakers:
1
Make sure you have set the Voltage Selector
and installed the proper fuse before proceeding.
(See “Setting the Voltage” on page 9 for details.)
2
Connect the included AC power cord to the
AC connector on the back panel of each speaker
(one power cord is included with each speaker).
3
Connect the other end of the AC power cord
to your power source.
Power Up and Power Down
Always power up your speaker system last (al-
lowing mixers, recorders and other devices to
fully power up first).
Conversely, always mute (or power off) your
speaker system first, before powering off other
devices in your studio.
Make sure to use a fuse rated at 2.5 Amps.
Do not use fuses of any other rating, or you
risk damage to the unit
Fuse holder
Fuse
holder
AC connector
AC
connector
