M-Audio DCP-200, User Manual

Page: 68 / 77

User Guide
68
DCP-200
10 Care and Maintenance
As with all furniture, avoid placing items directly on the piano (such as drink glasses, potted plants, etc.) that
may cause moisture damage to the piano’s finish.
Cleaning should be done with a soft, dry cloth (or if necessary, a slightly damp cloth). Chemical cleaning
products should not be used, as they may harm the piano’s finish.
11 Troubleshooting
Your DCP-200 digital piano has been tested under a wide variety of conditions to ensure trouble-free
performance. In the event that you do experience any difficulty, this section provides tips to help resolve some
basic issues you may encounter.
Problem : My piano keyboard is working correctly, but the pedals do not seem to be working.
Solution : Make sure the Pedal Board cable is firmly connected to the Pedal Connector on the piano’s rear
panel.
Problem : My piano is on with the volume turned up, but I do not hear any sound when I play the
keyboard.
Solution 1 : Local On/Off may be set to Off, or the currently selected voice’s volume may be turned down.
In either case, a Piano Reset will fix the problem. To do a Piano reset, press the Reverb button
and the Voice/Function button at the same time.
Solution 2 : If the Master Volume knob is turned up, but you do not hear sound from the piano’s built-in
speakers, make sure nothing is plugged into Headphone Output 1.
Problem : When I turn on the piano, the LED display does not light up, and I do not hear any sound.
Solution : Make sure one end of the AC cable is connected to the jack on the piano’s rear panel, and that
the other end is plugged into an electrical outlet. If the AC cable is plugged into a power strip,
make sure the power strip is switched on.
Problem : My piano is not recognized by my music software.
Solution : The USB cable between the computer and the DCP-200 piano must be connected (and the piano
powered on) before the music software is launched.
With the USB cable connected and DCP-200 powered on, try quitting the software and then
launching
it again.
Refer to the documentation which came with your software to learn how to make sure DCP-200
is properly selected within the software.
Note that on Windows XP computers, DCP-200 will show up as “USB Audio Device.”