M-Audio AXIOM 25-49-61, User Manual

Page: 15 / 45

14
3.1.2 Drawbar Mode
Drawbar mode is a quick method of reversing the direction of the nine sliders on your Axiom. If you are controlling an instrument that makes
use of drawbars rather than faders – the M-B3 electric organ on KeyRig for example, then you should use drawbar mode.
(The Drawbar function is not available on the 25 note version.)
To enable Drawbar mode, press the two buttons labelled Drawbar. When Drawbar mode is active, this will be indicated by the Drawbar symbol
in the LCD display.
The status of Drawbar mode can be saved in any of the 20 memory locations. It will also be remembered when you power down your
Axiom.
NOTE
: It is possible to reverse the direction of any control on your Axiom 25, 49 or 61, by switching the minimum and maximum limits for the
controller (refer to the previous section).
3.1.3 Turning Controls OFF
Stop a control from transmitting MIDI data by turning that control OFF. This is done as follows:
49 and 61 note versions:
<
Select the control as described in section 2.4.2.
<
Press the Ctrl Assign button and enter ‘000’ on the numeric keypad.
<
While the LCD is still flashing, press the data minus (–) button.
<
The LCD will now display ‘OFF’.
25 note version:
<
Select the control using the method described in section 2.4.2.
<
Press the Advanced button.
<
Press the Ctrl Assign key, and enter ‘000’ using the numeric data entry keys.
<
While the LCD is still flashing, press the data minus (–) button.
<
The LCD will now display ‘OFF’.
3.2 Recall And Store Of Your Control Setups
Once you have programmed the controls of your Axiom, you can store your setup into one of the 20 memory locations the Axiom offers.
The 20 locations are accessed using the Store and Recall buttons. Use the Store button to write your control setups to a memory location. Use the
Recall button to get your control setups back.
To store all of the current control settings on your Axiom:
49 and 61 note versions:
<
Press the Store button.
<
Enter the number of the memory location (1 to 20) using the numeric keypad.
25 note version:
<
Press the Advanced button.
<
Press the Store key.
<
Enter the number of the memory location (1 to 20) using the numeric data entry keys, or the –/+ buttons.
Section 3: Advanced Features