MM-007024-001
49
15 INITIAL POWER-UP TEST
1.
At the installation’s main ATC fuse holder located near the vehicle battery, open the fuse holder’s cap
and install the 30-amp ATC fuse. This fuse is a part of the Fuse Distribution Rail Kit (a part of Item 2
in Table 4-1). Push the cap back onto the holder until the plastic tab snaps into place.
2.
Optionally, fasten the cap to the wheel well or other vehicle surface via the hole in the cap’s mounting
tab and a self-threading screw (not supplied).
CAUTION
The installation’s main fuse is a 30-ampere ATC fuse. Installing the wrong fuse value
could lead to improper operation and/or damage. Verify the ATC fuse supplying power
to the Fuse Distribution Rail Assembly has the correct rating! The color of a 30-amp
ATC fuse is green.
3.
Carefully reconnect the vehicle’s battery ground cable.
4.
Verify the Control Head has powered-up by checking the display. If the display is not lit, depress the
on/off button for two (2) seconds until an asterisk appears on the display and the display lights up. If
necessary, see Section 8.1.
NOTE
Unlike many mobile radio products, the radio powers-up to the
state of last control
.
As long as the software configuration parameters have been loaded, successful installation is almost
immediately realized:
•
After a short boot-up sequence, the Control Head displays a channel number, the signal strength and
volume setting.
•
If no errors are displayed, the installation is most-likely properly wired.
•
If an error is displayed, recheck all cable connections, verify all fuses are properly installed, and
verify battery power is getting to the Fuse Blocks. If problems persist, contact M/A-COM’s Technical
Assistance Center (see page 13).
•
Consult the Operator’s Manual for operational information.
Refer to the following section for performance test information.