MM-007024-001
32
2.
Strip the end and connect it to the output power distribution side of the Fuse Block in accordance with
the instructions included with the block.
3.
Mate the DC Power Cable’s connector to the radio’s 3-pin power connector as follows: Visually align
the key and firmly push and turn the outer locking ring clockwise until it stops. A click will be sensed
to confirm proper mating.
CAUTION
Upon connection, verify the DC power cable is not under any stress, a service loop is
maintained, and the cable can be properly tied and stowed.
4.
Install the 15-Amp ATC fuse included in the Fuse Distribution Rail Kit into the Fuse Block’s fuse
slot.
CAUTION
Installing a fuse with the wrong amperage rating could cause an unsafe condition
and/or a prematurely blown fuse. Verify the correct fuse value for the radio is installed.
The color of the 15-amp fuse is blue.
5.
Tie and stow all cables/wires as necessary so they remain out of the way of casual contact, and so
wire chafe is avoided.
CAUTION
When servicing the radio and/or control head, always manually turn the units off and
then pull the main power fuse in the engine compartment.