MM23772, Rev. F
40
On P7250 model radios, when stealth mode is on, pressing any radio button (other
than the mic’s PTT button or the emergency button) on front panel will
immediately turn stealth mode off. For example, pressing the
button on the
front panel will turn stealth mode off.
8.18 ADJUST SIDE TONE AUDIO LEVEL
The radio sounds confirming tones called “side tones” when its buttons are pressed. Most users find this
audible confirmation helpful when navigating the menus. Side tone audio level can be adjusted or turned
completely off using the “Side Menu.”
For covert operations, it may be necessary to turn off side tones. For safety’s sake, turning off the radio
during covert operations is not recommended.
If the radio is operating properly but side tones are not heard when the menu buttons are pressed, the side
tones are probably turned off. To turn them back on, access the “Side Tone” menu and select a setting
other than “off.”
Use the following procedure to set side tone level:
1.
Press the
or
buttons to cycle through the menu until “Side Menu” is displayed.
2.
Press
or
to change to the desired level (Off, Low, Medium, and High). To turn side tones
completely off, use the “Off” setting.
8.19 CHANGE OPERATING MODE
P72720 Model Radios Only
:
Press 1# to transition from OTP to ECP. If ECP is not loaded in the radio, “No App” will be displayed.
P7250 and P72720 Model Radios
:
1.
Press the
or
buttons to cycle through the menu until “App Mode” is displayed.
2.
Press
or
to select the desired operating mode.
3.
Press
and use
or
to select Y or N.
4.
Press
again to make selection and return to the dwell display.
8.20 RECEIVE AND TRANSMIT VOICE CALLS
As soon as the radio completes the initialization sequence and registers on the OpenSky network, the user
will begin to hear calls from the talk groups in the active profile, if available.
8.20.1
Receive a Voice Call
No action is required on the part of the user.
No action is required to receive a voice call. The display responds to incoming voice calls as follows:
•
When the dwell display is set to received talk group and the scan mode is Normal or Fixed:
a.
If the received talk group matches the selected talk group, then the alias (if available) or user id of
the incoming caller is displayed.
