
1.
GENERAL SAFETY PRINCIPLES FOR
HONEY EXTRACTOR OPERATION
Prior to operating the device please refer to the manual and
act according to the guidelines contained therein. The
manufacturer cannot be held accountable for the damages
cause by misusing the device or its improper handling
1
.1. Operating principles
1.
Honey extractor is intended to extract honey from the
frames.
2.
Prior extraction, honey extractor shall be rinsed
thoroughly with hot water containing slight quantities of
agents accepted to be used in devices intended to come
into contact with food or by means of a pressure washer.
Remember to protect electronic components and the
bearing against getting wet!!!
1.2. Electric safety
1.
Electric installation must be equipped with RCD having
the nominal activation current below 30 mA. The operation
of the over-current circuit breaker must be checked
periodically.
2.
If a non-detachable supply cable or connecting cable get
damaged, they must be replaced. In order to avoid the
threat, it must be performed by a guarantor or by a
specialised servicing centre or by an authorised person.
Do not operate the honey extractor when a supply or
connecting cable are damaged!
3.
Prior to connecting the device to the mains, check
whether the controller is switched off. Switch on the
controlling panel shall be placed in “0” position.
4.
The nominal voltage of the honey extractor and the
power supply source must be checked for compatibility.
5.
Be careful while connecting the device to the mains.
Hands must be dry!
The floor on which the extractor has been placed must be
dry!
6.
While activating the honey extractor, emergency STOP
button must be switched off (it must be turned until it has
jumped out)
Pressing the emergency STOP button shall stop the
extractor operation immediately.
7.
While extracting, the lid of the honey extractor must be
closed ! it is strictly forbidden to open the lid during
extraction.
8.
The honey extractor must not be dislocated during
extraction.
1.
In case of a honey extractor with electric drive or
combined manual and electric drive, the engine and
controller must be protected against humidity; (also
during the storage) .
10.
It is forbidden to pull the supply cable. The supply cable
must be kept away from heat sources, sharp edges and it
god technical state must be taken care of.
1.3. Safety of operation
1.The following equipment is not intended to be used by
persons with limited physical, sensory or mental capabilities
(including children) or persons inexperienced or unfamiliar
with that type of equipment unless the usage occurs under
supervision or in line with the equipment operating manual
provided by safety supervising persons. One must make
sure that children do not play with the honey extractor.
2.
In case of any damage to the honey extractor, in order to
avoid the danger, the repairs may be performed solely by a
specialist servicing centre or a qualified person
3.
It is forbidden to perform any maintenance works or
repairs when the device is in operation or connected to the
mains!
4.
All shields must be permanently attached to the honey
extractor while operating it.
5.
In case of any danger, emergency switch must be used
at once. The honey extractor can be activated once the
threat has been eliminated.
6.
Devices are not intended to be used outdoors and may
be operated indoors only. .
7.
The device cannot be activated and stored with the
ambient temperature below 0º C.
Honey extractor cannot be activated when the ambient
temperature drops below 5º C. When the honey extractor
has been moved from a room with a lower temperature to a
room with a higher temperature, prior to its activation one
must wait until the device has achieved the ambient
temperature..
It is forbidden to repair the device under operation
It is forbidden to remove the shields under operation
Switch „0/1” on the controller casing in “1” position.
Place of work
It should be properly light and kept in order and cleanliness.