Page 8
For technical questions, please call 1-888-866-5797.
Item 63289
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
assembly instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
release trigger of the appliance before performing any procedure in this section.
note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual�
install Guard
WarninG! tO preVent SeriOuS
inJury FrOM FLyinG DeBriS: install the
guard only in the orientation shown.
1� Attach Guard to bottom of String
Trimmer with two included Screws�
2� Remove protective tape covering Line Cutter�
note:
Line Cutter is set to 13" cutting width�
3� To change cutting width to 11", remove Line Cutter
Screw, rotate Line Cutter, then replace Screw�
Guard
Screws
Line
cutter
protective
tape
Line
cutter
Screw
install auxiliary Handle
1� Slide Auxiliary Handle up on to Auxiliary
Handle Bracket until it clicks into place�
2� To change Auxiliary Handle position, move
Auxiliary Handle Lock up, change handle position,
then move Auxiliary Handle Lock down�
auxiliary
Handle
auxiliary
Handle
Bracket
auxiliary
Handle Lock
