Lynxmotion UAV
HQuad500 Frame Assembly Guide
2 - HQuad500 Assembly
We will explain the most optimal way to assemble the HQuad500 frame. Following this exact sequence is not
mandatory but suggested. Go over all the steps at least once before starting the build.
2.1 - Arm & Motor Mount Sub-Assembly
The following is the procedure for the assembly of one Motor Mount but, note that this same assembly should be
done four times for the four different arms on the HQuad500. Considering that the clamps are asymmetric, you must
take care to position them correctly.
Material Needed (each arm):
●
4x 16mm Aluminum Clamp Half
●
1x HQuad500 Top Motor Mount
●
1x HQuad500 Bottom Motor Mount
●
8x 440 x ¼” Hex screw
●
4x 440 x ¾” Hex screw
●
4x M3 x 5mm Hex screw
●
1x Lynxmotion Carbon Fiber Tube (16x14x220mm)
●
1x Brushless Motor
1.
Mount the clamps on the bottom motor mount using four 440 x ¼” Hex screws. You must use the two
threaded holes of the clamp to do so. Repeat the same step for the top motor mount as well.
Lynxmotion UAV HQuad500 Top & Bottom Clamps Assembly
Lynxmotion UAV
P.3
