1. Clip
Pull the rope using a sharp, crisp pull
so the rope comes free of the drive
pulley. Start the engine as per usual
manual starting.
When starting the snowmobile in an
emergency situation, using drive pul-
ley, do not reinstall the belt guard and
return slowly to have snowmobile re-
paired.
Shutting down the engine
Release throttle lever and wait until
engine has returned to idle speed.
Shut down the engine using either ig-
nition switch, engine cut-out switch or
tether cut-out switch.
NOTE:
In 4-tec models the shut down
the engine must be done only by en-
gine cut-out switch. This gives the fan
to operate longer if the engine has
gone under heavy pulling conditions
this is to prevent overheating. Do not
remove the tether cut-out switch until
the fan has stopped.
WARNING
Always remove tether cord cap
and key when vehicle is not in
operation in order to prevent acci-
dental engine starting or to avoid
unauthorized use by others or
theft.
_____________________
49
Summary of Contents for Yeti 550
