
LX-V12
LYNX Pro Audio S.L. -
Valencia, Spain -
www.lynxproaudio.com - [email protected]
ASSEMBLY AND ANGULATION OF LX-V12 CABINETS
The LX-V12 is easy to install. The Rainbow software provides all the necessary information to mount the array
cabinets with the required angles to get the calculated coverage and pressure.
The cabinets can be placed with variable angulation between 0º and 8.5º, with increases of 0.5º. Once the angle has
been determined for each of the cabinets, you have to set up the link pieces P2 in order to achieve this intercabinet
angle.
Place steel piece
P2
by moving knob so that the pin BALL-PSR can be inserted on each side in the necessary hole
with the determined degree for cabinet 2.
Removed the pins BALL-PSR12 located into the link pieces P1 and P2 at the bottom of cabinet 1. Select the
intercabinet angle between the cabinet and the next one by moving the knob of P2 in order to choose the angle. Then
introduce the pins in the hole which corresponds to the angle desired.
Once the link pieces P1 and P2 of cabinet 1 are in the correct position then remove the upper pins BALL-PSR12 from
the cabinet 2 and insert the link pieces
P1
and
P2
from cabinet 1 into the lateral steel plates slots of cabinet 2 (see
drawing on previous page). Insert the pins BALL-PSR12 again when the relevant holes coincide.
Now cabinet 2 is fixed to cabinet 1 with the corresponding inclination degree. Repeat the same process for the
remaining cabinets until all required cabinets are assembled in vertical array.
30
If all the cabinets are already linked and you want to modify the intercabinet angle you can do it easily when the array
is stacked on the floor. Just use the help of the lifting system to hang the cabinets during the operation.Link the array
to the flying frame, and fix the frame to the lifting system with the array staying on the floor. Simply remove the pins
located into the rear link pieces P2 of the cabinet to be modified. It is not necessary to remove the pins of the frontal
link pieces P1. Once the 2 pins are removed then lightly descend or lift the array using the lifting system. Just descend
or lift until you can change the intercabinet angle by moving the knob of P2. Once the new angle is selected and the
pins are inserted into the relevant holes of the upper cabinet then remove the pins of the cabinet following cabinet
and use the lifting system to lightly lift or descend the array until the link piece P2 is inserted into the following cabinet.
Insert the pins again to lock this position and repeat the same process with all the cabinets you want to modify.
P1
KNOB
P2
P1
BALL-PSR12
P2
POSITION 0º
BALL-PSR12
CABINET 2
CABINET 1
Summary of Contents for LX-V12
Page 37: ......