LYNX Pro Audio S.L. -
Valencia, Spain -
www.lynxproaudio.com [email protected]
LX-212S
SELECT THE INPUT: DIGITAL OR ANALOG
There are four input options: Analog / Digital L / Digital R / Digital L+R
To select the input mode just press the OK button (3) and the up button (1), both at the same time but pressing
the OK button first. Then you can select one of the four options using the up button (1). To confirm your selection
press OK (3) until the progress bar finishes. The display will show an inverted D (digital) or an inverted A (Analog)
so you can always know if the input is digital or analog.
CONFIGURING THE CABINETS DSP OPTIONS
From the buttons below the display on the Lynx cabinet’s back panel you are able to configure the Basic
adjustment functions of the internal DSP.
Note:
You must apply the desired configuration in each cabinet. This is done via the buttons located on the back
panel of the cabinet and requires electrical power to work.
CONFIGURATION PANEL
On the back panel you will see 3 buttons and an information screen, on which you can read the established
parameters and information such as digital or analog input, amplification module temperature, input signal level
and name of the current preset (Fig1). If changes are not made the display will automatically dim to save energy
and avoid unnecessary light in situations where light is not wanted. To re-activate the light simply press the OK
button.
10
Fig 1
1
2
3