Figure 2.
Duct Tape
Shipping Screws
Rough-in Plate
10" Transition
Shipping Screws
Rough-in Plate
Hood
Assembly
Transition
Figure 1.
Figure 3.
Centerline of
Rough-in Plate
Soffit
Rough-in Plate
10" Duct
STEP 1. INSTALLATION OF ROUGH-IN PLATE
1. The hood unit is shipped with the rough-in plate
and the transition attached.
Note: The transition is shipped upside down
within the hood unit and must be removed and
reinstalled. (See Figures 1 through 3.)
2. To detach the rough-in plate/transition from the
hood unit, remove the four (4) screws on the top
and four (4) screws on the back of the unit as
shown in Figure 1.
3. Detach the transition from the rough-in plate by
removing four (4) screws. The shipping screws
are needed for re-attaching the transition to the
rough-in plate.
4. Secure the transition to the top of the rough-in
plate, using four (4) screws provided. Use duct
tape to seal the joints of the transition and the
top of the rough-in plate. (See Figure 2.)
5. Mark the center of the rough-in plate and align
with the center of the soffit. (See Figure 3.)
6. Install rough-in plate to the soffit, using four (4)
#10x1" screws packed with the plate.
(See example for 36" hood in Figure 3).
These screws must be driven into the soffit
framing.
7. Secure the back side of the rough-in plate to the
wall stud.
Centerline
of Soffit
5
