12
CARE AND USE/INSTALLATION
4. If you are installing your keg refrigerator under a coun-
ter you will need to drill 5 holes in the counter top to
mount the tower. The first hole is a 1
1
⁄
2
" diameter hole
located at the center of the tower for the beverage line,
locate approximately 13
1
⁄
2
" (34.3 cm) from the front
edge of the counter top (based on a counter top depth
of 25
5
⁄
16
"). Next drill the 4 tower mounting holes per the
dimensions in Figure 27. The hole diameter is depen-
dent on the counter top material and if screw anchors
are required. The screws supplied are in the literature
pack and are a #10 x 1" type AB stainless steel screw.
Mark and cut the rectangular cutout for the drain sump.
After the holes are drilled and the keg refrigerator is
in place under the counter top feed the beverage line
through the tower gasket, the 1
1
⁄
2
" hole in the coun-
ter top and the hole in the top of the keg refrigerator.
Mount the tower to the counter top with the 4 screws
provided. Place the counter top drain sump, from the
literature pack, in the rectangular hole with the radius
cutout to the rear around the tower and place the grate
in the sump.
5. Mount the regulator to the gas tank (connection ).
Note that the regulator has left hand threads and has to
be turned counterclockwise to tighten. Tighten with the
adjustable wrench or the 1
1
⁄
8
" open end wrench.
6. Connect the red air line(s) from the regulator to the
large
air line fitting on the keg coupler with a
large
hose clamp (connection ).
7. Connect the clear beverage line from the tower to the
small
air line fitting on the keg coupler with a
small
hose clamp (connection ).
8. Locate the gas tank in the corner of the refrigerator as
shown in Figure 30 and secure with the chain. Close
A
C
B
Diameter
to suit
Rear of counter top
6
1
⁄
8
"
(15.6 cm)
12
1
⁄
4
"
(31.1 cm)
2
7
⁄
8
"
(7.3 cm)
4
1
⁄
4
"
(10.8 cm)
6
3
⁄
8
"
(16.2 cm)
1
3
⁄
8
"
(3.5 cm)
typical
1
1
⁄
2
(38 mm)
Diameter
counter
top depth
25
5
⁄
16
"
(64.3 cm)
1
⁄
4
" (6 mm)
radii,
typical
Figure 27
Figure 28
Figure 29
Grate from top of
beverage dis-
penser
Counter top
sump from
literature pack
Tower
!
CAUTION
The cutout dimensions shown in Figure 27 are based on
a 25
5
⁄
16
" (64.3 cm) deep counter top. Your counter top may
be different than this and require other front to back dimen
-
sioning. Refer to the product dimensions on pages 6 and 7
when determining the required dimensions.
NOTE
Your tower kit may or may not come with a "sit on top"
sump option. To use it please follow the instructions in the
tower kit.
USING YOUR BEVERAGE DISPENSER
