IMPORTANT SAFETY WARNINGS
US
SAVE THESE INSTRUCTIONS
This document contains important safety and operating instructions for the LXE MX1-IS MULTI-charger. Please
read all instructions and cautionary markings on the charger itself before putting the unit into service.
Safety Alert Symbols
This symbol is used to call your attention to instructions concerning your personal safety. Watch for
this symbol – it will alert you to important safety precautions that must be observed to avoid death,
personal injury or property damage. Follow the instructions after the warning symbol and be alert to
the possibility of personal injury or death.
These signal words provide users with information about the seriousness of the hazard involved:
DANGER WARNING
CAUTION
Indicates imminent hazards
which, if not avoided, WILL
result in severe personal injury
or death.
Indicates potential hazards
which, if not avoided, COULD
result in severe personal injury
or death.
Indicates hazards or unsafe practices
which, if not avoided, COULD result in
minor or moderate personal injury or
property damage.
Safety Instructions
Setting up the MX1-IS MULTI-charger
DANGER
This charger is NOT for use within a hazardous location. It is to be used only in non-hazardous
locations where the ambient temperature is between 10°C and 35°C (50°F and 95°F).
There is an external power supply between the wall and the charger. Plug the AC cord from the external power
supply into the wall and the DC power connector into the back of the charger.
Charge only LXE part no. 157873-0001 and 161139-0001 Rechargeable Lithium Ion Battery Packs in this charger.
Other batteries or battery packs may burst causing injury or property damage.
Operating the MX1-IS MULTI-charger
Only users who have read and understand all operating instructions are qualified to operate the charger. Failure to
read, understand and follow safety instructions may result in injury or death.
Keep the rear of the charger free of obstacles and do not block the rear ventilation slots. The charger generates
internal heat during charging.
Use care when inserting the battery. Do not "slam" the battery into the pocket. This action could damage the
charger.
Keep dirt and foreign objects out of the battery pocket. Do not short circuit any of the contacts in the battery pocket.
This action could result in injury or property damage.
Keep the charger away from any heat source. Excessive heating can ruin the charger. Do not operate the charger if it
has been dropped or damaged in any way. Return the charger to LXE.
Storing the MX1-IS MULTI-charger
Disconnect the charger from the external power supply by pulling the plug; not the cord. Disconnect the external
power supply from the AC source and store in a cool, dry location.
Maintaining the MX1-IS MULTI-charger
Service should be performed by trained persons only. Return the charger to LXE.