LVI KABA C, Installation And Operating Manual

Page: 13 / 16

GB
GENERAL
INFORMATION
KAB
A I
NS
TALLA
TION AN
D OPER
AT
ING M
AN
U
AL
01/07/2018
• LED 1 will start to flash red for 7 seconds. The quantity
of flashes correspond function being enabled or
disabled, as described below:-
1 flash = Adaptive Start disabled
2 flashes = Adaptive Start enabled
• To enable or disable the Adaptive Start function, rotate
dial B to either or
Auto , and then back to .
= Disable Adaptive Start
Auto = Enable Adaptive Start
• LED 1 will flash as described above.
• Wait 7 seconds to confirm.
• LED 2 will start to flash green for 7 seconds. The
quantity of flashes corresponds to the Open Window
Detection function being enabled or disabled, as
described below:-
1 flash = Open Window Detection disabled
2 flashes = Open Window Detection enabled
• To enable or disable the Open Window Detection
function, rotate dial B to either or
Auto , and then
back to .
= Disable Open Window Detection
Auto = Enable Open Window Detection
• LED 2 will flash as described above.
• Wait 7 seconds to confirm.
• After the 7 seconds has elapsed, the thermostat will
return to normal operation.
TROUBLE SHOOTING
If the red LED (1, picture 4) flashes rapidly and
continuously, a fault has been detected by the
electronics. Contact your supplier.
In the event of a power cut while the thermostat is set
to
Auto , or after a factory reset has been performed, LED
1 and LED 2 will continuously flash one after the other,
indicating that the thermostat has lost the time setting.
Follow the procedure
“HOW TO SELECT AND INITIATE
HEATING PROGRAMS”
.
FACTORY RESET
The user defined program and set point temperatures
can be reset to factory default settings. To perform a
factory reset, follow the below steps:-
25
30
20
15
10
Auto
25
30
20
15
10
Auto
+
x5
25
30
20
15
10
Auto
+
• Rotate dial B to Auto , then to , then back to Auto .
Repeat this sequence 5 times.
Auto Auto Auto Auto
Auto Auto
• LED 1 and LED 2 will then both flash 3 times.
• After this, LED 1 and LED 2 will continuously flash one
after the other, indicating that the thermostat has lost
the time setting.
5. MAINTENANCE, REPAIR
AND DISPOSAL
• WARNING : Disconnect electrical supply before carrying
out any maintenance activity.
• The product can be cleaned using a soft damp cloth.
Do NOT use chemical or abrasive cleaners as they will
damage the surface finish.
• The radiator is equipped with an overheat protection
that cannot be reset (melt fuse). This overheat
protection disconnects the current if the radiator
becomes too hot (e.g. when covered) or if, when
freestanding, is knocked over and left in this position.
• If the supply cord is damaged, it must be replaced by
the manufacturer, his service agent or similar qualified
persons in order to avoid a hazard.
• The radiator is filled with an exact amount of
environmental friendly vegetable oil. Any repairs that
require the radiator to be opened shall therefore only
be carried out by the manufacturer or his approved
agent. Please contact the manufacturer or his agent
in case of leakage.
• When scrapping the radiator, follow the regulations
concerning the disposal of oil.
13 |