![background image](http://html1.mh-extra.com/html/luxor/led-suwl30-xx/led-suwl30-xx_user-manual_1952643002.webp)
www.luxormarine-rv.ca • P.O. Box 20062 Pioneer Park, Kitchener, ON N2P 2B4 • Tel: 519-240-2882
USER MANUAL - LUXOR MARINE & RV
LuxOr LED Underwater Light - LED-SUWL30-XX
2. Drill 1/4” through hole in center of
desired location and feed power
wire through hole into boat. Hold
light flush against transom, mark
location for mounting screws,
then remove light. Drill pilot holes
for mounting screws to prevent
cracking in fiberglass hulls.
3. Use heavy grit sandpaper to rough
up the surface and to remove any
debris from drilling. Clean area
using alcohol and lint free cloth.
4. Apply uniform layer of marine
sealant to back side of light,
especially around mounting holes
and wire connection. Also apply
marine sealant to transom surface
around pilot and through holes.
5. Feed power wire back through
1/4” hole into boat and press light
against transom using uniform
pressure. Install mounting screws
with included neoprene washers
and tighten light to transom.
6. Use sealant that has squeezed
out from beneath light to create
complete seal around outer edge of
light. Remove any excess sealant.
7. Connect positive wire to positive
battery terminal through fuse
to switch (see diagram below).
Connect negative wire to negative
battery terminal. Marine grade heat
shrink butt connectors and ring
terminals are recommended.
8. Ensure light is solidly attached to
hull and that marine sealant has fully
cured prior to putting boat in water.
Lights may be tested briefly while
out of water. Lights will overheat
and shut down if operated out of
water for more than testing.
Installation Instructions
(continued)
Wiring Diagram
LED-SUWL30-XX Switch
Fuse Connector Battery