INTEGRATED AMPLIFIER L-507u
11
How to connect record player
Connect between the output terminal of an analog record
player and the PHONO terminal of this unit with 2 (R and L)
pin�plug cables. For some types of players, the ground wire
from the phono motor or the tone arm should be connected
to the ground terminal of this unit.
The phono equalizer of this unit uses the MM or MC car�
tridge. If an MC cartridge with low output voltage is used,
set the phono MC switch on the front panel to on.
The output from a record player equipped with a phono
equalizer or from an independent phono equalizer shall be
connected to the LINE input terminal of this unit.
How to connect recorder
1. Connection to monitor terminal
(playing)
Connect between the line output terminals (LINE OUT) of a
recorder and the monitor terminals of this unit with pin�plug
cables in consideration of R and L. Now, setting the input
selector to rec�1 or rec�2 provides playback.
2. Connection to REC OUT terminal
(recording)
When the sound source from the various input devices is
reproduced, which are connected to the PHONO or LINE
terminals of this unit, setting the recording selector to the
source to be recorded allows users to provide the REC OUT
terminal with the signal. Connection between the REC OUT
terminal of this unit and the line input terminals (LINE IN) of
the recorder with pin�plug cables is required for recording
on the recorder. After the connection, you can enjoy listen�
ing to the sound from the speaker system and record the
sound at the same time. These output signals for recording
are not affected by the control functions such as the volume
control and tone control functions.
When both of the input selector and the recording selector
are set to the line-2 position, the LINE-2 unbalance/bal-
ance selector toggles the recorder output terminals on the
rear between the unbalance input terminal (LINE-2) and
balance input terminal (BALANCED LINE-1)
When you need not toggle an input source to be recorded
(especially when a recorder connected to the recorder out-
put terminals is recording), do not operate this switch.
How to connect PRE OUT/MAIN IN terminal
Either the pre�amplifier or main�amplifier can be separately
used.
When the pre�amplifier or main�amplifier is separately used,
set the separate switch on the front panel to on.
When only the pre�amplifier is used, connect the PRE OUT
terminal of this unit to the input terminal of another power�
amplifier, and when only the main�amplifier is used, connect
the MAIN IN terminal of this unit to the output terminal of
another power�amplifier.
When this amplifier is used without separating between
pre-amplifier and main-amplifier, set the separate switch
on the front panel to off, or no sound is generated.
