CONTROL AMPLIFIER C-700u
11
5. External pre-input terminal
(EXT PRE IN)
RCA terminal to input output signals from an external
pre-amplifier or an AV amplifier
This terminal is connected to unbalanced output terminal
directly and outputs the signal connected to ext pre in.
External pre-input signals are not affected by the volume
control of this unit.
6. Remote output terminals
(REMOTE OUT)
If a power amplifier (e.g. M-700u) equipped with a dedicat-
ed remote input terminal is connected to this remote output
terminal with a dedicated remote cable, the power of the
power amplifier provided the signal can be turned on and
off by the operation switch of this unit.
ON signals from the remote output terminals are transmit-
ted in a certain period of time after pressing the operation
switch of this unit. Therefore, the power amplifier provided
the signal is activated after the time elapsed that consists of
the muting time of the power amplifier and this transmission
delay time.
The remote output terminals 1 and 2 can turn on and off 2
units of power amplifiers at the same time.
Refer to the owner’s manual of a signal-receiving power
amplifier for available operation settings of the signal-receiv-
ing power amplifier.
7. AC inlet (AC IN)
Connects the accessory power cable.
The power shall be supplied from a household wall socket.
8. Main power switch (MAIN POWER)
Turns this unit to the standby state.
When this switch is set to ON, the standby indicator on the
front panel lights up and shows that this unit turns to the
standby state.
When this switch is set to OFF, the standby indicator on the
front panel turns off to show that the main power is turned
off.
9. Balanced output terminals/OUTPUTS
(BAL LINE-1, BAL LINE-2)
XLR connector terminal to output balanced audio signals
from this unit
Connect these terminals to a balanced input of an output
device such as a power amplifier with a balanced cable.
Audio output signals are selected with the output mode se-
lection switch.
BAL LINE-1 and BAL LINE-2 are equivalent in quality.
Factory default output mode: Unbalanced (UNBAL)
10. Signal ground (ground terminal)
(SIGNAL GROUND)
Ground terminal for devices to be connected to this unit.
This terminal is used not for safety but for noise reduction
when other devices are connected.
11. Balanced input terminals/INPUTS
(BAL LINE-1, BAL LINE-2)
XLR connector input terminal to receive balanced audio sig-
nals of a line level.
Connect these terminals to a balanced output of an input
device such as a CD player with a balanced cable.
Incoming audio signals are selected with the input selector
and delivered.
BAL LINE-1 and BAL LINE-2 are equivalent in quality.
