4
WSP05 Rev. C1 03/2020
Luxier
Installation
A. Shut off water supply at the valves.
Remove old faucet and clean the
mounting surface for installation of new
faucet.
D. Apply Teflon (TPFE) tape on the
thread of the center spout brass pipe.
Use an adjustable wrench to tighten the
fittings. (NOTE: Do not overtighten the
connection.)
F. Insert hot and cold valves from under
-
neath the mounting surface. Secure the
handle assemblies with the decorative
trims from top of the mounting surface.
E. Use a small hex wrench to loosen the
small setscrew on the handle. Lift up the
decorative trim handle and remove all
trim pieces.
G. Apply Teflon (TPFE) plumbing tape
on both valve assemblies and shutoff
valves. Attach water supply hoses with
1/2” fittings (not included) with an ad
-
justable wrench. Also connect the water
hose between the handle assemblies
and the center spout. (NOTE: Do not
overtighten the connection.)
H. Use the aerator wrench to remove
the aerator. Turn on both hot and cold
handles and let the water run for about
1 minute to flush out any sediment or
debris inside the plumbing. Also check
for leaks at all connections.
I. Re-install the aerator once all con
-
nections are checked. Keep the aerator
wrench for future use. The installation is
complete at this time.
B. Place spout with flange through the
center mounting hole on the mounting
surface.
C. Insert the C shaped rubber / metal
washer and locking nut on the center
spout. Use an adjustable wrench to se
-
cure spout in place. (NOTE: Do not over
tighten the locking nut.)
A
B
C
D
F
Hot
Cold
G
H
E
I
